Workgroup Server PDS Card

Before you begin, remove the cover

Caution: You must unplug the computer prior to removing or installing the Workgroup Server 95 PDS card. Failure to unplug the computer could cause damage to the logic board and/or card.

1 Disconnect the SCSI data cable from the Workgroup Server PDS card.

2 Caution: Pull up evenly on both sides of the card to avoid bending the connector pins and remove the card.

Note: Grasp the rear of the card by the metal bracket.

Replacement Caution: When replacing the card, do not force it into the expansion slot. If the card does not seat properly, remove it and try again.

0 0

Post a comment

  • Receive news updates via email from this site